Removal And Installation

WARNING: To reduce the risk of accidental deployment, do not use any memory saver devices. Failure to follow this instruction may result in serious personal injury or death.

NOTE: The air bag warning indicator illuminates when the restraints control module (RCM) fuse is removed and the ignition switch is ON. This is normal operation and does not indicate a supplemental restraint system (SRS) fault.

NOTE: When installing a new climate control seat module (CCSM), it is necessary to carry out programmable module installation (PMI). For additional information, refer to MODULE CONFIGURATION .

NOTE: The SRS must be fully operational and free of faults before releasing the vehicle to the customer.

Before removing the climate control seat module (CCSM), carry out the appropriate steps in the programmable module installation (PMI) procedure. For additional information, refer to MODULE CONFIGURATION .
Position the front passenger seat to access all the seat track-to-floor bolts and the safety belt retractor belt anchor nut.
Depower the SRS. For additional information, refer to Supplemental Restraint System (SRS) Depowering and Repowering in the General Procedures portion of SUPPLEMENTAL RESTRAINT SYSTEM .
Remove the front passenger seat. For additional information, refer to Seat - Front .
Remove the CCSM.
- Disconnect the 3 electrical connectors.
- Remove the 2 screws.
- Remove the CCSM.
To install, reverse the removal procedure.
Install the front passenger seat and repower the SRS. Do not prove out the SRS at this time. For additional information, refer to Seat - Front .
Carry out the Occupant Classification Sensor (OCS) System Zero Seat Weight Test and prove out the SRS. For additional information, refer to the General Procedures portion of SUPPLEMENTAL RESTRAINT SYSTEM .
Install the CCSM software data. Carry out the appropriate steps in the PMI procedure. For additional information, refer to MODULE CONFIGURATION .