LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Ford >> 2007 >> Edge SEL Plus, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1492 (Brake System - General Information) >> Diagnostic Tests >> Brake System >> Inspection and Verification - Adjustable Pedals With Memory Feature
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Inspection and Verification - Adjustable Pedals With Memory Feature

WARNING: This page is about a different car, the 2010 Lincoln Town Car. However, it is still accessible from the selected car via links, so may be relevant.
  1. Verify the customer concern by operating the adjustable pedals.
    2. NOTE: If the adjustable pedals are not installed on the vehicle, when a self-test is carried out, the driver seat module (DSM) will set pedal codes.
  2. Visually inspect for obvious signs of mechanical or electrical damage. Refer to the following chart:
    VISUAL INSPECTION CHART

    Mechanical Electrical
    • Adjustable pedals
    • Adjustable pedal cable
    • Adjustable pedal motor
    • Foreign material
    • Remote transmitter
    • Adjustable pedal switch
    • Battery junction box (BJB) fuse 601 (20A)
    • Driver seat module (DSM)
    • Memory SET switch
    • Central junction box (CJB) fuse 14 (15A)
    • Wiring, terminals or connectors
  3. If an obvious cause for an observed or reported concern is found, correct the cause (if possible) before proceeding to the next step.
    4. NOTE: Make sure to use the latest scan tool software release.
  4. If the cause is not visually evident, connect the scan tool to the data link connector (DLC).
    5. NOTE: The vehicle communication module (VCM) LED prove out confirms power and ground from the DLC are provided to the VCM.
  5. If the scan tool does not communicate with the VCM:
    • check the VCM connection to the vehicle.
    • check the scan tool connection to the VCM.
    • refer to MODULE COMMUNICATIONS NETWORK article, No Power To The Scan Tool, to diagnose no communication with the scan tool.
  6. If the scan tool does not communicate with the vehicle:
    • verify the ignition key is in the ON position.
    • verify the scan tool operation with a known good vehicle.
    • refer to MODULE COMMUNICATIONS NETWORK article to diagnose no response from the PCM.
  7. Preform the network test.
    • If the scan tool responds with no communication for one or more modules, refer to MODULE COMMUNICATIONS NETWORK article.
    • If the network test passes, retrieve and record continuous memory DTCs.
  8. Clear the continuous DTCs and preform the self-test diagnostics for the DSM.
  9. If the DTCs retrieved are related to the concern, go to DRIVER SEAT MODULE (DSM) DTC INDEX . For all other DTCs, refer to the Master DTC Table in MULTIFUNCTION ELECTRONIC MODULES article.
  10. If no DTCs related to the concern are retrieved, go to Symptom Chart - Adjustable Pedals With Memory Feature .
scientia non olet · About LEMON Manuals