Driver Air Bag Module: Installation
WARNING: This page is about a different car, the 2007 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.
- With the locking buttons released, install the driver air bag module electrical connectors fully into the driver air bag module and seat the locking buttons.
- Install the 2 driver air bag module bolts.
- Tighten to 6 Nm (53 lb-in).
- Repower the SRS. For additional information, refer to Supplemental Restraint System (SRS) Depowering and Repowering in the General Procedures portion of this section.
CAUTION:
Do not install the driver air bag module electrical connectors by the locking buttons. Damage to the locking buttons may occur.
CAUTION:
The driver air bag module electrical connector locking buttons must be in the released position when the connector is being installed or connector damage may occur.
CAUTION:
The driver air bag module electrical connectors are unique and cannot be reversed when connected to the driver air bag module. Match the electrical connector key to the keyway in the driver air bag module. Do not force the electrical connectors into the driver air bag module. Damage to the connector or component may occur.