LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Ford >> 2007 >> Edge SEL Plus, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 927 (Climate Control System - General Information And Diagnostics) >> Diagnostic Tests >> Climate Control System >> Component Tests >> A/C Compressor - External Leak Test
April 5, 2026: LEMON Manuals is launched! Read the announcement.

A/C Compressor - External Leak Test

WARNING: This page is about a different car, the 2007 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the A/C pressure test adapter on the rear head of the A/C compressor using the existing manifold retaining bolt.
  2. Connect the high and low pressure lines of a manifold gauge set or a refrigerant recovery/recycling station such as R-134a A/C service center to the corresponding fittings on the A/C pressure test adapter.
  3. Attach the center hose of the manifold gauge set to a refrigerant container standing in an upright position.
  4. Hand-rotate the compressor shaft 10 complete revolutions to distribute the oil inside the A/C compressor.
  5. Open the low pressure gauge valve, the high pressure gauge valve and the valve on the refrigerant container to allow the refrigerant vapor to flow into the A/C compressor.
  6. Using the Automatic Calibration Halogen Leak Detector, check for leaks at the compressor shaft seal and the compressor center seal.
  7. If a shaft seal leak is found, install a new shaft seal. Refer to CLIMATE CONTROL article. If an external leak is found at the center joint of the A/C compressor, install a new A/C compressor.
  8. When the leak test is complete, recover the refrigerant from the compressor.
scientia non olet · About LEMON Manuals