Removal And Installation

WARNING: This page is about a different car, the 2007 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.

Remove the steering wheel. For additional information, refer to STEERING COLUMN .

Fig 1: Locating Steering Wheel Rear Cover Screws

Courtesy of FORD MOTOR CO.

Remove the steering wheel rear cover.
- Remove the 2 screws.
- Remove the steering wheel rear cover.

Fig 2: Removing Ribbon Harness From Clips

Courtesy of FORD MOTOR CO.

Remove the ribbon harness from the clips.

Fig 3: Locating Horn Contact Electrical Connectors

Courtesy of FORD MOTOR CO.

Disconnect the horn contact electrical connectors.

Fig 4: Right Side Horn Contact With Torque Specification

Courtesy of FORD MOTOR CO.

Remove the right side horn contact.
- Remove the 2 screws.
  - To install, tighten to 7 Nm (62 lb-in).
- Remove the horn contact.

Fig 5: Speed Control Switch Assembly With Torque Specification

Courtesy of FORD MOTOR CO.

Remove the speed control switch assembly.
- Remove the 4 screws.
  - To install, tighten to 7 Nm (62 lb-in).
- Remove the speed control switch assembly.
To install, reverse the removal procedure.