Removal And Installation

WARNING: This page is about a different car, the 2007 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.

Disconnect the speed control actuator electrical connector.

Fig 1: Pushing In Locking Arm On Speed Control Cable Cap & Rotate Cap Counterclockwise

Courtesy of FORD MOTOR CO.

Remove the speed control cable cap from the speed control actuator.
- Push in the locking arm on the speed control cable cap and rotate the cap counterclockwise.

Fig 2: Identifying Spring Retainer & Speed Control Cable

Courtesy of FORD MOTOR CO.

Remove the speed control cable.
- Press the spring retainer.
- Slide the core wire end out of the speed control actuator pulley and remove the speed control cable.
Remove the bolt and the speed control actuator and bracket assembly.
- To install, tighten to 11 Nm (8 lb-ft).

Fig 3: Identifying Speed Control Actuator Bracket Bolts

Courtesy of FORD MOTOR CO.

Remove the 3 bolts and separate the speed control actuator bracket from the speed control actuator.
- To install, tighten to 9 Nm (80 lb-in).

NOTE: Make sure the rubber seal is fully seated onto the speed control cable cap.

To install, reverse the removal procedure.