Steering Control Module: Service and Repair

Power Steering Control (PSC) Module

Removal and Installation
1. Remove the air cleaner assembly.
2. Remove the battery junction box (BJB) bracket nuts on the strut tower.
^ Position the BJB aside.

3. Disconnect the power steering control module electrical connectors.
4. Remove the 2 power steering control module nuts.
^ To install, tighten to 23 Nm (17 ft. lbs.).

5. Remove the power steering control module ground cable bolt.
6. Remove the power steering control module nuts from inside the vehicle.
^ To install, tighten to 23 Nm (17 ft. lbs.).

7. Remove the power steering control module.
8. To install, reverse the removal procedure.