Pump Assembly: Assembly

WARNING: This page is about a different car, the 2007 Lincoln Navigator L and 2007 Lincoln Navigator. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Prior to installation, lightly lubricate the pump gears with clean automatic transmission fluid.

Install the pump gears, with the dot facing the control body assembly.

Fig 1: Locating Pump Gear Dots

Courtesy of FORD MOTOR CO.

Install a new pump body outer seal.

Fig 2: Locating Pump Body Outer Seal

Courtesy of FORD MOTOR CO.

Assemble the control body and stator assembly onto the pump body and install the bolts.
- Tighten to 15 Nm (11 lb-ft).

Fig 3: Locating Plate Assembly To Pump Body Bolts

Courtesy of FORD MOTOR CO.

CAUTION: Make sure the seal ends are correctly positioned together and not separated.

Install the 2 coast clutch Teflon® seals. Make sure the seals are fully seated in the stator support seal grooves and the seal ends are oriented 180 degrees apart.

Fig 4: Front Pump Stator Support Seals

Courtesy of FORD MOTOR CO.

Install the pump outer diameter front pump O-ring seal.

Fig 5: Locating Front Pump O-Ring Seal

Courtesy of FORD MOTOR CO.

Using the special tool, install the front pump seal.

Fig 6: Identifying Special Tool

Courtesy of FORD MOTOR CO.

NOTE: Lightly lubricate the thrust washer with petroleum jelly to hold it in place during assembly.

Install the pump thrust washer.

Fig 7: Locating Front Pump Washer

Courtesy of FORD MOTOR CO.