Specifications Index
EXPLORER & MOUNTAINEER & EXPLORER SPORT TRAC SPECIFICATIONS INDEX
| System | Specification/Procedure | ||||
|---|---|---|---|---|---|
| Air Conditioning | |||||
| Service | SPECIFICATIONS | ||||
| Torque | SPECIFICATIONS | ||||
| Axle Nut/Hub Nut | |||||
| Front | 184 lb.ft (250 Nm) | ||||
| Rear | 203 lb.ft (275 Nm) | ||||
| Battery | SPECIFICATIONS | ||||
| Brakes | |||||
| Bleeding Sequence | BRAKE SYSTEM BLEEDING | ||||
| Disc & Drum Brakes w/Torque | SPECIFICATIONS | ||||
| Charging | |||||
| Generator | SPECIFICATIONS | ||||
| Torque | SPECIFICATIONS | ||||
| Drive Belts | |||||
| Adjustment | BELT TENSIONER - MECHANICAL | ||||
| Belt Routing | ACCESSORY DRIVE | ||||
| Engine Cooling | |||||
| General Service Specifications | SPECIFICATIONS | ||||
| Radiator Cap Pressure | 18-22 psi (124-152 kPa) | ||||
| Thermostat R & I | |||||
| 4.0L SOHC | THERMOSTAT - 4.0L SOHC | ||||
| 4.6L (3V) | THERMOSTAT - 4.6L (3V) | ||||
| Water Pump R & I | |||||
| 4.0L SOHC | COOLANT PUMP - 4.0L SOHC | ||||
| 4.6L (3V) | COOLANT PUMP - 4.6L (3V) | ||||
| Engine Mechanical | |||||
| 4.0L SOHC | |||||
| Compression | COMPRESSION TEST - COMPRESSION GAUGE CHECK | ||||
| Oil Pressure | 15 psi (103 kPa) minimum oil pressure at normal temperature and 2000 RPM. | ||||
| Overhaul | GENERAL SPECIFICATIONS | ||||
| Torque | TORQUE SPECIFICATIONS | ||||
| 4.6L (3V) | |||||
| Compression | COMPRESSION TEST - COMPRESSION GAUGE CHECK | ||||
| Oil Pressure | 75 psi (517 kPa) hot @ 2000 RPM | ||||
| Overhaul | GENERAL SPECIFICATIONS | ||||
| Torque | TORQUE SPECIFICATIONS | ||||
| Fluid Specifications | See FLUIDS under MAINTENANCE tab. From within Manager or Service Writer, click the "30/60/90 Interval" or "Maint." button. | ||||
| Flywheel/Flex Plate Torque | |||||
| 4.0L SOHC | INSTALLATION | ||||
| 4.6L (3V) | REMOVAL AND INSTALLATION | ||||
| Fuel System | |||||
| Fuel Filter Location | On leading edge of fuel tank on right side of vehicle, mounted behind fuel filter shield. | ||||
| Fuel Filter R & I | REMOVAL AND INSTALLATION | ||||
| Pressure Release Procedure | FUEL SYSTEM PRESSURE RELEASE | ||||
| Pressure Specification | FUEL PRESSURE SPECIFICATIONS | ||||
| Fuel Pressure Test Procedure | A: No Start STEP A9 CHECK THE FUEL PRESSURE | ||||
| Ignition | |||||
| Firing Order & Cylinder Identification | |||||
| 4.0L SOHC | FIRING ORDER & CYLINDER IDENTIFICATION | ||||
| 4.6L (3V) | FIRING ORDER & CYLINDER IDENTIFICATION | ||||
| Ignition Coil (Cylinder Identification) | |||||
| 4.0L SOHC | COIL PACK | ||||
| 4.6L (3V) | Coil On Plug | ||||
| Ignition Wires (Routing) | N/A | ||||
| Spark Plugs (1)SEE FOOTNOTE | |||||
| 4.0L SOHC | |||||
| Type LH Type RH |
Motorcraft AGSF-24N | ||||
| Gap | .052-.056 In. (1.32-1.42 mm) | ||||
| Torque | 13 Ft. Lbs. (17 N.m) | ||||
| 4.6L (3V) | |||||
| Type | Motorcraft PZT-2F | ||||
| Gap | .040-.050 In. (1.15+/-0.13 mm) | ||||
| Torque | 25 Ft. Lbs. (34 N.m) | ||||
| Starting | |||||
| Starter | SPECIFICATIONS | ||||
| Torque | SPECIFICATIONS | ||||
| Wheel Alignment | |||||
| Adjustment Specifications | ALIGNMENT SPECIFICATIONS | ||||
| Torque | TORQUE SPECIFICATIONS | ||||
| Wheel & Tire | |||||
| Wheel Lug Nut Torque | 100 Ft. Lbs. (135 N.m) | ||||
|
|||||