Removal And Installation

If equipped, remove the watershield.
- Remove the screw.
- Remove the 2 pin-type retainers.

Fig 1: Identifying Pin-Type Retainers

Courtesy of FORD MOTOR CO.

Disconnect the speed control cable from the throttle body linkage.
- Rotate the throttle body linkage and disconnect the speed control cable end by pushing forward.

Fig 2: Locating Speed Control Cable

Courtesy of FORD MOTOR CO.

Position the speed control cable away from the throttle body bracket retaining ring.

Fig 3: Positioning Speed Control Cable

Courtesy of FORD MOTOR CO.

Remove the speed control cable from the throttle body bracket.
- Using a suitable tool, remove the retaining ring from the throttle body bracket.

Fig 4: Locating Retaining Ring

Courtesy of FORD MOTOR CO.

Fig 5: Locating Retaining Clips

Courtesy of FORD MOTOR CO.

Fig 6: Locating Speed Control Actuator Electrical Connector

Courtesy of FORD MOTOR CO.

Remove the 3 bolts and the speed control actuator.
- To install, tighten to 9 Nm (80 lb-in).

Fig 7: Locating Speed Control Actuator Bolts With Torque Specifications

Courtesy of FORD MOTOR CO.

Press the locking tab and rotate the speed control cable cover counterclockwise to remove.

Fig 8: Accelerator Cable Bracket Locking Tab

Courtesy of FORD MOTOR CO.

Remove the speed control cable from the speed control actuator pulley.
1. Press the spring retainer.
2. Slide the core wire end out of the speed control actuator pulley and disconnect the speed control actuator cable.

Fig 9: Speed Control Cable At Speed Control Actuator Pulley

Courtesy of FORD MOTOR CO.

CAUTION: A new speed control cable must be installed.

NOTE: Make sure downward pressure is applied to the speed control actuator cable cover prior to rotating it clockwise.