Front Controls Interface Module (FCIM) DTC Chart
WARNING: This page is about a different car, the 2010 Mercury Mariner and 2010 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
This module utilizes a 5-character DTC followed by a 2-character failure-type code. The failure-type code provides information about specific fault conditions such as opens or shorts to ground. Continuous memory DTCs have an additional 2-character DTC status code suffix to assist in determining DTC history.
FRONT CONTROLS INTERFACE MODULE (FCIM) DTC CHART
| DTC | Description | Action |
|---|---|---|
| U0140:00 | Lost Communication With Body Control Module (GEM ): No Sub Type Information | GO to PINPOINT TEST AA . |
| U0184:00 | Lost Communication With Radio (ACM ): No Sub Type Information | GO to PINPOINT TEST AS . |
| U2013:63 | Switch Pack: Circuit/Component Protection Time-Out | GO to PINPOINT TEST R . |
| U2014:41 | Control Module Hardware: General Checksum Failure | CLEAR the DTCs. REPEAT the self-test. If DTC U2014:41 is retrieved again, INSTALL a new Front Controls Interface Module (FCIM). REFER to FRONT CONTROLS INTERFACE MODULE (FCIM) . TEST the system for normal operation. |
| U201A:51 | Control Module Main Calibration Data: Not Programmed | CLEAR the DTCs. REPEAT the self-test. If DTC U201A:51 is retrieved again, INSTALL a new FCIM . REFER to FRONT CONTROLS INTERFACE MODULE (FCIM) . TEST the system for normal operation. |
| U3003:16 | Battery Voltage: Circuit Voltage Below Threshold | GO to PINPOINT TEST AD . |
| U3003:17 | Battery Voltage: Circuit Voltage Above Threshold | GO to PINPOINT TEST AN . |