Compass Calibration

NOTE: For optimum calibration, drive to an open, level location away from large metallic objects or structures. Switch off all non-essential electrical accessories (heated rear window, heater fan, A/C, map lamps, and wipers) and make sure all doors are closed.

Start the vehicle.
Press and hold the MODE button until CAL appears in the display, then release the MODE button.

NOTE: To exit the CAL mode before carrying out a compass adjustment, turn the ignition key to the OFF position.

NOTE: While holding the MODE button down, the compass display will first enter the ZONE setting mode (after 5 seconds) and then after another 5 seconds (10 seconds total), the compass display will enter the CAL mode.

Press and hold the MODE button for approximately 10 seconds until CAL appears in the display, then release the MODE button.

NOTE: If the CAL indicator does not turn off after the vehicle is driven in a circle at least 5 times, repeat the procedure.

Drive the vehicle slowly at less than 5 km/h (3 mph) in a continuous circle until CAL disappears from the display and the compass heading is shown.
If the CAL message does not turn off within 5 circles (and the procedure has been repeated at least once), install a new overhead console. For additional information, refer to INSTRUMENT PANEL AND CONSOLE article.