Removal And Installation

Edge only 

1. Pull the switch bezel straight up to unclip it from the door trim panel.

MKX only 

NOTE: LH front shown, all others similar.
2. Pull up on the front edge of the switch bezel and pull forward to unhook it from the door trim panel.
Fig 1: Pulling Up On Front Edge Of Switch Bezel & Pulling Forward To Unhook It From Door Trim Panel
Courtesy of FORD MOTOR CO.

All vehicles 

3. Disconnect the electrical connector(s).
4. Unclip the window control switch from the switch bezel.
5. To install, reverse the removal procedure.