Removal And Installation
- Upload the SDARS module configuration information to the scan tool. For additional information, refer to Programmable Module Installation (PMI) in MODULE CONFIGURATION article.
- Remove the liftgate scuff plate. For additional information, refer to Interior Trim - Exploded View in INTERIOR TRIM AND ORNAMENTATION article.
- Remove the 2 nuts and the SDARS module.
- Disconnect the satellite radio antenna connector and the electrical connector.
- To install, tighten the nuts to 7 Nm (62 lb-in).
- To install, reverse the removal procedure.
- Download the configuration information to the SDARS module. For additional information, refer to PMI in MODULE CONFIGURATION article.
NOTE:
Module configuration is only required if a new satellite digital audio receiver (SDARS) module is being installed.