Removal and Installation
WARNING: This page is about a different car, the 2010 Lincoln MKX and 2010 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
This procedure applies to vehicles without navigation, which has the satellite radio receiver built-in to the Audio Control Module (ACM).
- Upload the SDARS module configuration information to the scan tool. For additional information, refer to Programmable Module Installation (PMI) in MODULE CONFIGURATION .
- Remove the liftgate scuff plate. For additional information, refer to Interior Trim - Exploded View in INTERIOR TRIM AND ORNAMENTATION .
- Remove the 2 nuts and the SDARS
module.
- Disconnect the satellite radio antenna connector and the electrical connector.
- To install, tighten the nuts to 7 Nm (62 lb-in).
- To install, reverse the removal procedure.
- Download the configuration information to the SDARS module. For additional information, refer to PMI in MODULE CONFIGURATION .
NOTE:
Module configuration is required when a new Satellite Digital Audio Receiver System (SDARS) module is being installed.