LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Ford >> 2008 >> Escape Base, 2.3 Z, AWD, Standard >> Repair and Diagnosis >> Transmission >> Manual Trans >> Manual Transmission External Controls >> Removal And Installation >> Gearshift Lever >> Installation
October 30: LEMON manuals on a temporary server, it is slow and having issues, download the manuals you need! Later in November we will switch back to the fast server.

Gearshift Lever: Installation

  1. Position the gearshift lever.
  2. Connect the gearshift cables to the gearshift lever.
    3. Fig 1: Select Cable
    GF0025433Courtesy of FORD MOTOR CO.
    Fig 2: Gearshift Cable
    GF0025434Courtesy of FORD MOTOR CO.
    CAUTION: Make sure the clips are set completely within the cable adapter groove and fully seated.
  3. Install the 2 gearshift cable clips.
    4. Fig 3: Gearshift Cable Clips
    GF0025435Courtesy of FORD MOTOR CO.
  4. Install the 4 gearshift lever nuts.
    • Tighten to 25 Nm (18 lb-ft).
  5. Adjust the gearshift cables. For additional information, refer to MANUAL TRANSAXLE/TRANSMISSION AND CLUTCH - GENERAL INFORMATION article.
  6. Install the floor console finish panel.
  7. Install the gearshift lever knob and boot assembly.
scientia non olet · About LEMON Manuals