Alternate Diagnostic Methods - Electronic Automatic Temperature Control (EATC) Module Only: Notes

The EATC system must be diagnosed by first retrieving any DTCs, if present.

• An on-demand (hard fault) DTC indicates that the fault is currently present. An on-demand DTC suggests a wiring fault, disconnected connector or component failure.
• A continuous (intermittent) DTC alone (corresponding on-demand DTC is not present) indicates that the fault is an intermittent condition and may not be currently present. A continuous only DTC suggests a poor wiring connection, loose pin or terminal or intermittent component failure.

On-demand (hard fault) or continuous (intermittent fault) DTCs can be retrieved using a scan tool. If using a scan tool, refer to the scan tool operating manual.

On-demand DTCs can also be retrieved by carrying out the Electronic Automatic Temperature Control (EATC) Module On-Demand Self Test. To retrieve and/or clear continuous DTCs, carry out the Electronic Automatic Temperature Control (EATC) Module - Retrieve Continuous DTCs procedure. Always carry out the Electronic Automatic Temperature Control (EATC) Module On-Demand Self Test before retrieving continuous DTCs.

If no DTCs are present, go to Symptom Chart  for the appropriate diagnostic action.