LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Ford >> 2008 >> Escape Base, 3.0 1, FWD >> Repair and Diagnosis (Single Page) >> Engine Performance >> Remove, Overhaul & Install >> Electronic Engine Control System - 3.0L (4V) >> Removal And Installation >> Powertrain Control Module (PCM) >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Powertrain Control Module (PCM): Installation

  1. Install the PCM and the 2 stud bolts.
    • Tighten to 9 Nm (80 lb-in).
  2. Connect the 3 PCM electrical connectors.
  3. Position the manifold absolute pressure (MAP) sensor and the wiring harness and install the 2 PCM stud bolt nuts.
    • Tighten to 9 Nm (80 lb-in).
  4. Restore the module configuration. Carry out the module configuration restore steps of the Programmable Module Installation procedure. For additional information, refer to MODULE CONFIGURATION article.
  5. Reprogram the passive anti-theft system (PATS). Carry out the Key Programming Using Two Programmed Keys procedure. For additional information, refer to ANTI-THEFT - PASSIVE ANTI-THEFT SYSTEM (PATS) article.
scientia non olet · About LEMON Manuals