Digital Transmission Range (TR) Sensor: Installation

WARNING: This page is about a different variant/trim than selected.

CAUTION: The digital transmission range (TR) sensor must fit flush against the boss on the case to prevent damage to the sensor.

Fig 1: Locating Transmission Range (TR) Sensor

Courtesy of FORD MOTOR CO.

CAUTION: Tightening one screw before tightening the other may cause the sensor to bind or become damaged.

NOTE: The manual lever must be in the NEUTRAL position.

Using the special tool, align the digital TR sensor and tighten the screws in an alternating sequence.
- Tighten 8 Nm (71 lb-in).

Fig 2: Identifying Special Tool (307-351)

Courtesy of FORD MOTOR CO.

Fig 3: Locating Shift Cable Eyelet At Manual Control Lever

Courtesy of FORD MOTOR CO.

Fig 4: Locating Digital Transmission Range (TR) Sensor Connector

Courtesy of FORD MOTOR CO.

Install the transmission crossmember-to-floor pan screws.
- Tighten to 63 Nm (46 lb-ft).

Fig 5: Locating Transmission Crossmember-To-Floor Pan Screws

Courtesy of FORD MOTOR CO.

Verify that the selector lever cable is adjusted correctly. For additional information, refer to AUTOMATIC TRANSAXLE/TRANSMISSION EXTERNAL CONTROLS article.