Electronic Brake Control Module: Service and Repair

Anti-Lock Brake System (ABS) Module









Removal and Installation

All vehicles

1. Remove the 3 bolts and position the degas bottle aside.
- To install, tighten the bolts to 10 Nm (89 lb-in).





Vehicles equipped with 6.0L engine or Hydro-Boost(R)

2. Remove the Air Cleaner (ACL).

All vehicles

3. Disconnect the ABS module electrical connector.
- Release the lock tab.

- Pull the connector from the module.





4. Remove the 4 screws and the ABS module.
- To install, tighten the screws to 5 Nm (44 lb-in).

5. To install, reverse the removal procedure.
- For vehicles equipped with Roll Stability Control (RSC(R)), carry out the IVD Initialization sequence. Follow the scan tool directions.