Removal and Installation
WARNING: This page is about a different car, the 2009 Ford Flex. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
It is not necessary to remove the Audio Control Module (ACM
) to retrieve the part number. For additional information, refer to AUDIO CONTROL MODULE (ACM) SELF-DIAGNOSTIC MODE .
All vehicles
- Upload the ACM
configuration information to the scan tool. For additional information, refer to
MODULE CONFIGURATION
.
Vehicles without navigation
- Remove the center instrument panel finish panel. For additional information, refer to
INSTRUMENT PANEL AND CONSOLE
.
Vehicles with navigation
- Remove the Front Display Interface Module (FDIM). For additional information, refer to FRONT DISPLAY INTERFACE MODULE (FDIM) .
All vehicles
- Remove the 4 screws and the ACM
.
- Disconnect the electrical connectors and the antenna lead-in cable.
- To install, reverse the removal procedure.
- Download the configuration information to the ACM . For additional information, refer to MODULE CONFIGURATION .
NOTE:
Module configuration is required when a new ACM
is being installed.