Front Controls Interface Module (FCIM): Installation

WARNING: This page is about a different car, the 2009 Ford Flex. However, it is still accessible from the selected car via links, so may be relevant.

Align the FCIM to the instrument panel center finish panel so there is a consistent gap at the top of the FCIM .

Fig 1: Locating Instrument Panel Center Finish Panel
Courtesy of FORD MOTOR CO.

NOTE: Lightly hand-tighten the screws. Do not use power tools.

Install the 17 screws (vehicles without navigation) or 8 screws (vehicles with navigation).
- Adjust the FCIM , if necessary, by loosening the top screws, then re-tightening.
Install the instrument panel center finish panel. For additional information, refer to INSTRUMENT PANEL AND CONSOLE .