PINPOINT TEST A: DTCs B106E/B106F - SOLID STATE DRIVER DISABLED/MODULE DISABLED

WARNING: This page is about a different car, the 2008 Mercury Mariner and 2008 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION: If DTC B106F is present and the SJB is to be replaced, the fault condition must be corrected first. Failure to correct the fault condition first may cause damage to the new SJB, resulting in a repeat repair.

A1 CHECK FOR DTC B106E
- Review the DTCs from the SJB self-test.
- Is DTC B106E present?
1. YES : Go to A2.
2. NO : Go to A3.
A2 CHECK FOR OTHER DTCs
- Review the DTCs from the SJB self-test.
- Are any SJB DTCs present other than DTC B106E?
1. YES : CORRECT any other DTCs. REFER to Diagnostic Trouble Code (DTC) Chart . REPEAT the on-demand self-test.
2. NO : CLEAR the DTCs. REPEAT the self-test. TEST the system for normal operation.
A3 CHECK FOR DTC B106F
- Review the DTCs from the SJB self-test.
- Is DTC B106F present?
1. YES : CORRECT any other DTCs. REFER to Diagnostic Trouble Code (DTC) Chart . INSTALL a new SJB. REFER to Smart Junction Box (SJB) . TEST the system for normal operation.
2. NO : The system is operating correctly at this time. The concern was caused by a fault in one of the output circuits.