Removal And Installation
WARNING: This page is about a different car, the 2008 Mercury Sable, 2008 Ford Taurus X, and 2008 Ford Taurus. However, it is still accessible from the selected car via links, so may be relevant.
Wagon
- Remove the 2 screws and the steering wheel controls bezel.
- Remove the 2 screws and the speed control switch.
- Disconnect the electrical connector.
- To install, tighten to 7 Nm (62 lb-in).
- Remove the driver air bag module. For additional information, refer to SUPPLEMENTAL RESTRAINT SYSTEM article.
- Remove the 2 screws and the speed control switch.
- Disconnect the electrical connector.
- To install, tighten to 7 Nm (62 lb-in).
- To install, reverse the removal procedure.
Sedan
All vehicles