Powertrain Control Module (PCM): Installation
WARNING: This page is about a different car, the 2009 Ford Flex. However, it is still accessible from the selected car via links, so may be relevant.
- Install the PCM and the 2 nuts.
- Tighten to 8 Nm (71 lb-in).
- Connect the 3 PCM electrical connectors.
- Install the cowl panel grille. For additional information, refer to FRONT END BODY PANELS .
- Restore the module configuration. Carry out the module configuration restore steps of the Programmable Module Installation (PMI) procedure. For additional information, refer to MODULE CONFIGURATION .
- Reprogram the Passive Anti-Theft System (PATS). Carry out the Parameter Reset procedure. For additional information, refer to ANTI-THEFT - PASSIVE ANTI-THEFT SYSTEM (PATS) .