Removal and Installation

WARNING: This page is about a different car, the 2009 Ford RV Cutaway, 2009 Ford Econoline, 2009 Ford E450 Super Duty, and 2009 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.

Retrieve the module configuration. Carry out the module configuration retrieval steps of the Programmable Module Installation (PMI) procedure. For additional information, refer to MODULE CONFIGURATION .
Turn the ignition switch to the OFF position.
Remove the 3 bolts and position the degas bottle aside.
- To install, tighten to 10 Nm (89 lb-in).
  
  Fig 1: Locating Degas Bottle Aside And Bolts
  Courtesy of FORD MOTOR CO.

NOTE: Make sure both latches are released before removing the electrical connectors or connector damage can occur.

Fig 2: Locating Fuel Injection Control Module Electrical Connectors

Courtesy of FORD MOTOR CO.

Disconnect the Fuel Injection Control Module (FICM) electrical connectors.
Remove the 4 bolts and the FICM .
- To install, tighten to 13 Nm (115 lb-in).
  
  Fig 3: Locating FICM And Bolts
  Courtesy of FORD MOTOR CO.
To install, reverse the removal procedure.
- If the fuel injector control module was replaced, restore the module configuration. Carry out the module configuration steps of the Programmable Module Installation (PMI) procedure. For additional information, refer to MODULE CONFIGURATION .