Removal and Installation

WARNING: This page is about a different car, the 2009 Ford RV Cutaway, 2009 Ford Econoline, 2009 Ford E450 Super Duty, and 2009 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.

Turn the ignition switch to the OFF position.
Retrieve the module configuration. Carry out the module configuration retrieval steps of the Programmable Module Installation (PMI) procedure. For additional information, refer to MODULE CONFIGURATION .
Remove the 6 pushpin retainers and the upper air deflector.

Fig 1: Locating Pushpin Retainers And Upper Air Deflector
Courtesy of FORD MOTOR CO.
Remove the 4 power steering reservoir bracket bolts.

Fig 2: Locating Power Steering Reservoir Bracket Bolts
Courtesy of FORD MOTOR CO.
Remove the power steering fluid indicator and 3 bolts. Remove the power steering reservoir bracket. Install the power steering indicator and position aside.

Fig 3: Locating Power Steering Fluid Indicator, Power Steering Reservoir Bracket And Bolts
Courtesy of FORD MOTOR CO.
Disconnect the coolant hoses from the Air Cleaner (ACL) outlet pipe.

Fig 4: Locating Coolant Hoses And Air Cleaner Outlet Pipe
Courtesy of FORD MOTOR CO.

NOTE: ACL side shown, engine side similar.

Fig 5: Locating ACL Outlet Pipe And Clips

Courtesy of FORD MOTOR CO.

Loosen the clamps and remove the ACL outlet pipe.
Unlatch and disconnect the PCM electrical connectors.

Fig 6: Locating PCM Electrical Connectors
Courtesy of FORD MOTOR CO.
Remove the bolt and PCM.

Fig 7: Locating PCM And Bolt
Courtesy of FORD MOTOR CO.