LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Ford >> 2009 >> Edge SE, AWD >> Repair and Diagnosis >> Steering >> Manual Steering >> Steering System - General Information >> Diagnostic Tests >> Steering System >> Component Tests >> Steering Linkage Test
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Steering Linkage Test

    NOTE: Excessive vertical motion of the studs relative to the sockets may indicate excessive wear.
  1. With the vehicle on the ground and the parking brake applied, start the vehicle and carry out the following:
    • Have an assistant rotate the steering wheel back and forth 360 degrees and watch for relative motion of the studs in the steering linkage ball sockets.
    • Watch for loose steering gear mounting.
  2. As an additional check, with the Key ON Engine OFF (KOEO) and the front wheels raised off the ground, grasp the wheel at the front and rear and watch for excessive play or binding in the joints while trying to steer the wheels.
  3. Install new components if necessary. Tighten any worn, damaged or loose components. Refer to the appropriate Steering System article for the procedure.