Speed Control Deactivator Switch: Installation

WARNING: This page is about a different car, the 2009 Ford Econoline. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Do not allow brake fluid to contact the electrical connector.

Install the deactivator switch.
- Add a few drops of brake fluid to the fluid port on the threaded side of the switch before installing it.
- Tighten to 18 Nm (159 lb-in).
- Connect the electrical connector.
  
  Fig 1: Adding Few Drops Of Brake Fluid To Fluid Port On Threaded Side Of Switch
  Courtesy of FORD MOTOR CO.
Check the master cylinder fluid level and adjust as necessary.