Audio Control Module (ACM)

Audio Control Module (ACM)

All Except Navigation










Navigation









Removal and Installation

All vehicles

1. NOTE: Module configuration is only required if a new ACM is being installed.

Upload the ACM configuration to the scan tool.

2. Remove the middle instrument panel center finish panel.

3. Remove the 4 ACM screws.
- To install, tighten to 2 Nm (18 lb-in) (navigation).

- To install, tighten to 1 Nm (9 lb-in) (all except navigation).

Navigation

4. Disconnect the antenna and electrical connectors.

All except navigation

5. If equipped, remove the 4 screws and the ACM side support brackets.

6. NOTE: Only carry out this step if installing a new ACM.

Remove the 2 ACM brackets.

All vehicles

7. Remove the ACM.

8. To install, reverse the removal procedure.
- Download the configuration information to the ACM.