Removal and Installation
WARNING: This page is about a different variant/trim than selected.
NOTE:
The gearshift lever boot and gearshift lever knob is one assembly.
- Separate the gearshift lever boot from the floor console.
- Cut the gearshift lever knob crimp ring.
- Remove the gearshift lever knob and gearshift lever boot assembly.
- To install, reverse the removal procedure.
- Crimp the ring to 40 Nm (30 lb-ft).
NOTE:
The gearshift lever boot has been removed for clarity.
NOTE:
A fully seated knob will conceal the knurled section on the gearshift lever. Failure to fully seat the gearshift knob may cause gearshift lever boot damage.