Removal And Installation
WARNING: This page is about a different car, the 2009 Mercury Grand Marquis and 2009 Ford Crown Victoria. However, it is still accessible from the selected car via links, so may be relevant.
- With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING article.
- Remove the 2 bolts and the intake manifold shield.
- To install, tighten to 12 Nm (9 lb-ft).
- Disconnect the EGR system module tube-to-EGR system module fitting.
- To install, tighten to 43 Nm (32 lb-ft).
- Disconnect the EGR system module tube-to-exhaust manifold fitting.
- To install, tighten to 43 Nm (32 lb-ft).
- Remove the EGR system module tube from the vehicle.
- To install, reverse the removal procedure. If equipped with fire suppression system, repower the system.
WARNING:
Before servicing a vehicle equipped with a fire suppression system, depower the system by following the procedure in FIRE SUPPRESSION SYSTEM
article. Failure to follow the instructions may result in serious personal injury.
WARNING:
If the vehicle is equipped with a fire suppression system, repower the system. For important safety warnings and procedures, refer to FIRE SUPPRESSION SYSTEM
article. Failure to follow these instructions may result in serious personal injury.