Removal and Installation
NOTE:
On vehicles equipped with Roll Stability Control (RSC®), the ABS module and the Hydraulic Control Unit (HCU) are calibrated to one another. Do not swap ABS modules between RSC®
-equipped vehicles.
NOTE:
On vehicles equipped with RSC®
, the ABS module is available separately from the HCU
and should be serviced separately. However, if the RSC®
-equipped vehicle requires a new HCU
, then the ABS module and the HCU
must be installed as an assembly. Make sure to use the most recently released service parts.
NOTE:
When installing a new ABS module/ HCU
assembly, it must be configured (either by download/upload or uploading the as-built data method). For additional information, refer to Programmable Module Installation (PMI) in
MODULE CONFIGURATION
article.
- Release the Air Cleaner (ACL) cover retaining clips and disconnect the Mass Air Flow (MAF) sensor electrical connector.
- Loosen the ACL outlet clamp and disconnect the ACL cover from the outlet pipe.
- To install, tighten to 4 Nm (35 lb-in).
- Remove the 3 HCU
bracket-to-frame bolts.
- To install, tighten to 20 Nm (177 lb-in).
- Disconnect the ABS module electrical connector.
- Remove the 4 ABS module bolts and the ABS module.
- To install, tighten to 2 Nm (18 lb-in).
- To install, reverse the removal procedure.
- If installing a new ABS module on a vehicle equipped with RSC® , configure the ABS module. For additional information, refer to Programmable Module Installation (PMI) in MODULE CONFIGURATION article.
- If installing a new ABS module on a vehicle equipped with RSC® , calibrate the RSC® sensor. Connect the scan tool and carry out the IVD Initialization sequence.