Removal and Installation

Vehicles with floor shift 

1. Remove the front floor console. For additional information, refer INSTRUMENT PANEL AND CONSOLE article.
2. Remove the 4 bolts and the front floor console support bracket.
   • To install:
     • Tighten the upper bolts to 9 Nm (80 lb-in).
     • Tighten the lower bolts to 40 Nm (30 lb-ft).
   Fig 1: Locating Front Floor Console Support Bracket Bolts

   Courtesy of FORD MOTOR CO.

   Vehicles with column shift 

3. Remove the stability control sensor cover.

All vehicles 

4. Disconnect the stability control sensor cluster electrical connector.
5. Remove the 2 bolts and the stability control sensor cluster.
   • To install, tighten to 12 Nm (106 lb-in).
6. To install, reverse the removal procedure.

• Connect the scan tool and carry out the IVD Initialization sequence.