Removal and Installation
NOTE:
Electronic modules are sensitive to electrical charges. The Anti-lock Brake System (ABS) module can be damaged if exposed to these charges.
- Remove the Hydraulic Control Unit (HCU). For additional information, refer to HYDRAULIC CONTROL UNIT (HCU) .
- Remove and discard the 4 screws.
- To install, tighten the new screws to 3 Nm (27 lb-in).
- Remove the ABS module.
- To install, reverse the removal procedure.
NOTE:
When installing a new ABS module, it must be configured using vehicle as-built data. For additional information, refer to Programmable Module Installation (PMI) in
MODULE CONFIGURATION
.