LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Ford >> 2009 >> Fusion S, Standard >> Repair and Diagnosis >> Transmission >> Manual Trans >> Manual Transmission >> Disassembly And Assembly Of Subassemblies >> Input Shaft >> Assembly
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Input Shaft: Assembly

NOTE: Do not reassemble the input shaft dry.
  1. Lubricate all input shaft components with the recommended transmission lubricant during reassembly.
  2. Using the special tool, press on the new bearing.
    3. Fig 1: Identifying Special Tools (205-090, 307-181) And New Bearing
    GF0030005Courtesy of FORD MOTOR CO.
  3. Install 3rd gear.
  4. Assembly the synchronizer.
    1. Position the synchronizer hub and sleeve together.
    2. Install the synchronizer hub inserts.
    3. Install the synchronizer blocking spring.
    4. Rotate the synchronizer and install the opposite synchronizer blocking spring.
    5. Fig 2: Identifying Synchronizer Hub Assembly
    GF0010559Courtesy of FORD MOTOR CO.
    NOTE: When installing the synchronizer blocking ring, align the synchronizer blocking ring groove and synchronizer hub inserts.
    NOTE: Make sure to have the ridge facing the 3rd gear when installing the synchronizer hub assembly.
    NOTE: Make sure that the 4 grooves in the synchronizer hub are facing the 3rd gear.
  5. Using the special tools, press on the synchronizer blocking ring and synchronizer hub assembly.
    6. Fig 3: Pressing On Synchronizer Blocking Ring & Synchronizer Hub Assembly Using Special Tools (205-090, 308-155)
    GF0030006Courtesy of FORD MOTOR CO.
    NOTE: Rotate the input shaft.
  6. Install a new snap ring.
    7. Fig 4: Locating Snap Ring
    GF0030000Courtesy of FORD MOTOR CO.
    CAUTION: Press the bearing onto the input shaft by the inner race only. Pressing on the outer race will damage the bearing.
    NOTE: Rotate the input shaft.
    NOTE: When installing the synchronizer blocking ring, align the synchronizer blocking ring groove and synchronizer hub inserts.
  7. Using the special tools, press on the synchronizer blocking ring, 4th gear and a new bearing.
    8. Fig 5: Pressing On Synchronizer Blocking Ring, 4th Gear & Bearing Using Special Tools (205-D064)
    GF0030007Courtesy of FORD MOTOR CO.
    NOTE: If not within specifications, disassemble and reassemble the input shaft assembly.
  8. Measure the input shaft clearances.
    1. Measure the clearance between the 3rd and 2nd gears.
      • 2nd gear end play is 0.018-0.46 mm (0.007-0.018 in) maximum end play is 0.51 mm (0.020 in).
    2. Measure the clearance between the 4th gear and the bearing cone.
      • 4th gear end play is 0.17-0.37 mm (0.007-0.014 in) maximum end play is 0.42 mm (0.017 in).
    9. Fig 6: Identifying Clearance Between 3rd And 2nd Gears And Between 4th Gear And Bearing Cone
    GF0029997Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals