Removal And Installation
WARNING: This page is about a different car, the 2009 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.
- Upload the SDARS module configuration information to the scan tool. For additional information, refer to Programmable Module Installation (PMI) in MODULE CONFIGURATION .
- Set the RH luggage compartment trim aside.
- Remove the push-pins, as required.
- Remove the 4 nuts and the SDARS module.
- Disconnect the electrical connectors.
- To install, tighten the nuts to 7 Nm (62 lb-in).
- To install, reverse the removal procedure.
- Download the configuration information to the SDARS module. For additional information, refer to PMI in MODULE CONFIGURATION .
NOTE:
Module configuration is only required if a new Satellite Digital Audio Receiver System (SDARS) module is being installed.
NOTE:
When installing the nuts, tighten the 2 rear nuts before tightening the front 2 nuts.