Removal And Installation
WARNING: This page is about a different car, the 2008 Mercury Sable, 2008 Ford Taurus X, and 2008 Ford Taurus. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
Electronic modules are sensitive to electrical charges. The anti-lock brake system (ABS) module can be damaged if exposed to these charges.
NOTE:
When installing a new ABS module, it must be configured (using vehicle as-built data) and calibrated. Follow the scan tool directions for the calibration procedures. For module configuration, refer to MODULE CONFIGURATION
article.
- Remove the hydraulic control unit (HCU). For additional information, refer to Hydraulic Control Unit (HCU) .
- Remove and discard the 4 screws.
- To install, tighten the new screws to 3 Nm (27 lb-in).
- Remove the ABS module.
- To install, reverse the removal procedure.