Removal and Installation
WARNING: This page is about a different car, the 2010 Mercury Mariner and 2010 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
Do not use any fluid other than clean brake fluid meeting manufacturer's specification. Additionally, do not use brake fluid that has been previously drained. Following these instructions will help prevent system contamination, brake component damage and the risk of serious personal injury.
WARNING:
Carefully read cautionary information on product label. For EMERGENCY MEDICAL INFORMATION seek medical advice. In the USA or Canada on Ford/Motorcraft products call: 1-800-959-3673. For additional information, consult the product Material Safety Data Sheet (MSDS) if available. Failure to follow these instructions may result in serious personal injury.
NOTE:
Do not spill brake fluid on painted or plastic surfaces or damage to the surface may occur. If brake fluid is spilled onto a painted or plastic surface, immediately wash the surface with water.
NOTE:
Do not swap ABS modules between vehicles. The ABS module and the Hydraulic Control Unit (HCU) are calibrated as an assembly.
Hybrid vehicles
- Remove the HCU
. For additional information, refer to HYDRAULIC CONTROL UNIT (HCU) - HYBRID .
Non-hybrid vehicles
- Remove the HCU . For additional information, refer to HYDRAULIC CONTROL UNIT (HCU) .
- Remove the jumper tube assembly bracket nut.
- To install, tighten to 9 Nm (80 lb-in).
- Disconnect the jumper tubes fittings from the HCU
and remove the jumper tube assembly.
- To install, tighten to 15 Nm (133 lb-in).
All vehicles
- Remove the 4 ABS module screws and the ABS module.
- To install, tighten to 2 Nm (18 lb-in).
- To install, reverse the removal procedure.