Removal and Installation

WARNING: This page is about a different car, the 2010 Mercury Milan, 2010 Lincoln MKZ, and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: It is not necessary to remove the Audio Control Module (ACM) to retrieve the part number. For additional information, refer to AUDIO CONTROL MODULE (ACM) SELF-DIAGNOSTIC MODE .

All vehicles

NOTE: Module configuration is required when a new ACM is being installed.

Upload the ACM configuration information to the scan tool. For additional information, refer to PROGRAMMABLE MODULE INSTALLATION (PMI) .
Vehicles with navigation
Remove the Front Display Interface Module (FDIM). For additional information, refer to FRONT DISPLAY INTERFACE MODULE (FDIM) - FUSION, MILAN .
Vehicles without navigation
Remove the instrument panel center finish panel. For additional information, refer to INSTRUMENT PANEL AND CONSOLE .
All vehicles
Remove the 4 screws (2 for navigation) and the ACM .
- Disconnect the electrical connectors.
NOTE: For vehicles with navigation, the 2 upper screws were removed with the FDIM .
To install, reverse the removal procedure.
- Download the ACM configuration information from the scan tool. For additional information, refer to PMI in MODULE CONFIGURATION .