Powertrain Control Module (PCM): Installation
WARNING: This page is about a different car, the 2009 Mercury Mountaineer, 2009 Ford Explorer Sport Trac, and 2009 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.
All vehicles
- Install the PCM and bolts.
- Tighten to 10 Nm (89 lb-in).
- Connect the PCM electrical connectors.
- Position the wiring harness and the A/C tube bracket(s) and install the nut(s). Connect the RH front wheel speed sensor electrical connector.
- Tighten to 7 Nm (62 lb-in).
- Install the air cleaner. For additional information, refer to INTAKE AIR DISTRIBUTION AND FILTERING article.
- Restore the module configuration. Carry out the module configuration restore steps of the Programmable Module Installation procedure. For additional information, refer to MODULE CONFIGURATION article.
- Reprogram the passive anti-theft system (PATS). Carry out the Parameter Reset procedure. For additional information, refer to ANTI-THEFT - PASSIVE ANTI-THEFT SYSTEM (PATS) article.
Vehicles equipped with a 4.6L (3V) engine
All vehicles