LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Ford >> 2010 >> Fusion Sport, AWD >> Repair and Diagnosis (Single Page) >> Transmission >> Automatic Trans >> Automatic Transaxle - AISIN Aw21 >> In-Vehicle Repair >> Transmission Control Module (TCM) >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Transmission Control Module (TCM): Installation

  1. Verify that the manual lever position markings are aligned. Markings should indicate that the manual lever is in the OVERDRIVE position.
    Fig 1: Identifying Manual Lever Position Markings
    G06264030Courtesy of FORD MOTOR CO.
  2. Install the TCM  .
    • Tighten to 24 Nm (18 lb-ft).
    Fig 2: Locating TCM & Bolts
    G06264029Courtesy of FORD MOTOR CO.
  3. Install the manual control lever.
    Fig 3: Locating Manual Control Lever
    G06264028Courtesy of FORD MOTOR CO.
  4. Install the manual control lever nut.
    • Tighten to 12 Nm (106 lb-in).
    Fig 4: Locating Manual Control Lever Nut
    G06264027Courtesy of FORD MOTOR CO.
  5. Connect the TCM  electrical connector.
    Fig 5: Identifying TCM Electrical Connector
    G06264026Courtesy of FORD MOTOR CO.
  6. Connect the selector lever cable end.
    NOTE: Support the underside of the manual control lever when installing the selector lever cable or damage to the manual control lever or shaft may occur.
    Fig 6: Locating Selector Lever Cable End
    G06269831Courtesy of FORD MOTOR CO.
  7. Install the ACL  assembly. For additional information, refer to REMOVAL AND INSTALLATION .
  8. Connect the battery ground cable. For additional information, refer to REMOVAL AND INSTALLATION (2.5L), REMOVAL AND INSTALLATION (3.0L) and REMOVAL AND INSTALLATION (3.5L) .
  9. Carry out the TCM  initial learning procedure. For additional information, refer to TRANSMISSION CONTROL MODULE (TCM) INITIAL LEARNING .
  10. Check for correct vehicle operation.
scientia non olet · About LEMON Manuals