Transmission Control Module (TCM): Installation

Verify that the manual lever position markings are aligned. Markings should indicate that the manual lever is in the OVERDRIVE position.

Fig 1: Identifying Manual Lever Position Markings
Courtesy of FORD MOTOR CO.
Install the TCM .
- Tighten to 24 Nm (18 lb-ft).
Fig 2: Locating TCM & Bolts
Courtesy of FORD MOTOR CO.
Install the manual control lever.

Fig 3: Locating Manual Control Lever
Courtesy of FORD MOTOR CO.
Install the manual control lever nut.
- Tighten to 12 Nm (106 lb-in).
Fig 4: Locating Manual Control Lever Nut
Courtesy of FORD MOTOR CO.
Connect the TCM electrical connector.

Fig 5: Identifying TCM Electrical Connector
Courtesy of FORD MOTOR CO.
Connect the selector lever cable end.
NOTE: Support the underside of the manual control lever when installing the selector lever cable or damage to the manual control lever or shaft may occur.

Fig 6: Locating Selector Lever Cable End
Courtesy of FORD MOTOR CO.
Install the ACL assembly. For additional information, refer to REMOVAL AND INSTALLATION .
Connect the battery ground cable. For additional information, refer to REMOVAL AND INSTALLATION (2.5L), REMOVAL AND INSTALLATION (3.0L) and REMOVAL AND INSTALLATION (3.5L) .
Carry out the TCM initial learning procedure. For additional information, refer to TRANSMISSION CONTROL MODULE (TCM) INITIAL LEARNING .
Check for correct vehicle operation.