Removal and Installation

NOTE: Electronic modules are sensitive to electrical charges. The Anti-lock Brake System (ABS) module can be damaged if exposed to these charges.

NOTE: This step is necessary only if a new ABS module is being installed on a vehicle equipped with a 4.6L engine.

Connect the scan tool and upload the module configuration information from the ABS module. For additional information, refer to MODULE CONFIGURATION .
Remove the Air Cleaner (ACL) assembly. For additional information, refer to INTAKE AIR DISTRIBUTION & FILTERING .
Disconnect the ABS module electrical connector.
Remove the 4 screws and the ABS module.
- To install, tighten to 3 Nm (27 lb-in) in the sequence shown in illustration.
  
  Fig 1: Identifying ABS Module Screws In Sequence
  Courtesy of FORD MOTOR CO.
To install, reverse the removal procedure.
If a new ABS module was installed, carry out these steps in the following sequence.
1. For vehicles equipped with a 4.6L engine, download the module configuration information from the scan tool. For additional information, refer to MODULE CONFIGURATION .
2. Using the scan tool, carry out the IVD Initialization sequence.