Transmission Range (TR) Sensor: Installation
- Install the TR sensor (automatic transaxle shown removed for clarity).
- Using the Transmission Range Sensor Alignment Tool, align the TR
sensor and tighten the bolts.
- Tighten to 10 N.m (89 lb-in).
- Install the manual control lever.NOTE: Do not use air tools on this bolt. Hold the manual control lever while tightening the manual control lever bolt, or failure to the manual control lever shaft or the Transmission Range (TR) sensor could occur.
- Tighten to 30 N.m (22 lb-ft).
- Adjust the manual control lever to TR
sensor D position.NOTE: Check the manual control lever is in position 3 (D position) or the selector lever cable will not be adjusted correctly.
- "1" M1
- "2" M2
- "D" Drive
- "N" Neutral
- "R" Reverse
- "P" Park
- When in position D, the marks on the manual control lever line up with the marks on the TR sensor.
- Connect the selector lever cable and the TR sensor electrical connector.
NOTE:
Failure to hold the manual control lever while loosening or tightening the manual control lever bolt will transmit rotational torque to the TR
sensor and shift mechanism.
NOTE:
Do not fully tighten the bolts at this stage.