Removal and Installation
WARNING: This page is about a different car, the 2006 Mercury Grand Marquis and 2006 Ford Crown Victoria. However, it is still accessible from the selected car via links, so may be relevant.
- With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
- Remove the 2 bolts and the intake manifold shield.
- To install, tighten to 12 Nm (9 lb-ft).
- Disconnect the tube fitting at the exhaust gas recirculation (EGR) system module.
- To install, tighten to 40 Nm (30 lb-ft).
- Disconnect the EGR tube nut at the exhaust manifold.
- To install, tighten to 40 Nm (30 lb-ft).
- Remove the EGR tube from the vehicle.
- To install, reverse the removal procedure. If equipped with fire suppression system, repower the system.
WARNING:
If equipped with fire suppression system, depower the system. For important safety warnings and procedures, refer to FIRE SUPPRESSION SYSTEM
.
WARNING:
If equipped with fire suppression system, repower the system. For important safety warnings and procedures, refer to FIRE SUPPRESSION SYSTEM
.