LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Ford >> 2011 >> Edge Limited, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 2085 (MULTIFUNCTION Electronic Modules) >> Removal And Installation >> Remote Function Actuator (RFA) Module >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Remote Function Actuator (RFA) Module: Installation

WARNING: This page is about a different car, the 2014 Lincoln MKX and 2014 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the RFA  module onto the studs and install the 2 nuts.
  2. Connect the RFA  module electrical connectors.
  3. NOTE: If the RFA  module was not replaced, this is the last step that is necessary.

    Install the glove compartment. For additional information, refer to INSTRUMENT PANEL - EXPLODED VIEW .

  4. Carry out the parameter reset between the RFA  module and the Body Control Module (BCM). For additional information, refer to PASSIVE ANTI-THEFT SYSTEM (PATS) PARAMETER RESET .
  5. Program the Intelligent Access (IA) keys (minimum of 2) into the new RFA  module. For additional information, refer to KEY PROGRAMMING USING DIAGNOSTIC EQUIPMENT .
  6. Turn the ignition ON.
  7. Carry out the keyless entry keypad code reset. For additional information, refer to KEYLESS ENTRY KEYPAD CODE PROGRAMMING .
  8. Download the RFA  module configuration information from the scan tool into the new RFA  module. For additional information, refer to MODULE CONFIGURATION .
  9. Carry out the RFA  module self-test to confirm all DTCs have been cleared.
scientia non olet · About LEMON Manuals