Remote Function Actuator (RFA) Module: Removal
WARNING: This page is about a different car, the 2014 Lincoln MKX and 2014 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
If a new Remote Function Actuator (RFA) module is installed, verify at least 2 of the vehicle keys are available prior to carrying out this procedure.
NOTE:
If a new Remote Function Actuator (RFA) module is installed, the ignition does not turn on until a parameter reset is performed and 2 keys are programmed.
-
NOTE: This step is only necessary if the RFA module is being replaced.
Upload the module configuration information from the RFA module. For additional information, refer to MODULE CONFIGURATION .
- Remove the glove compartment. For additional information, refer to INSTRUMENT PANEL - EXPLODED VIEW .
- Disconnect the RFA module electrical connectors.
- Remove the 2 nuts and the RFA module.