Cruise-Control Module (C-CM): Installation
WARNING: This page is about a different car, the 2014 Lincoln MKX and 2014 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.
Bracket
- Install the 4 bolts and the C-CM
bracket assembly.
- Tighten the bolts to 8 Nm (71 lb-in).
C-CM or bracket
-
NOTE: If a plastic grommet breaks while the C-CM is being installed, a new grommet should be installed.
Firmly apply pressure to the C-CM so that it seats completely in the grommets.
- Once the C-CM is installed, pull the C-CM to confirm that all 3 ball studs are fully seated in the grommets.
- Connect the C-CM connector.
- If a new C-CM was installed, it must be configured (using vehicle as-built data or module configuration information retrieved earlier in this procedure). For additional information on configuration, refer to PROGRAMMABLE MODULE INSTALLATION (PMI) .
- Vertically and horizontally align the C-CM . For additional information, refer to CRUISE CONTROL MODULE (C-CM) (WITH SENSOR) ADJUSTMENT .
- Install the front bumper cover. For additional information, refer to BUMPERS .