Removal and Installation
WARNING: This page is about a different car, the 2014 Lincoln MKX and 2014 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.
All vehicles
- Remove the LH and RH floor console upper finish moulding. For additional information, refer to the EDGE FLOOR CONSOLE FINISH PANELS
.
Edge
- Place the transmission selector lever in neutral.
-
NOTE: The floor console selector lever panel does not need to be removed.
Remove the 4 screws, detach the 2 clips and position the floor console selector lever trim panel back.
- Remove the 6 Front Controls Interface Module (FCIM) screws and remove the FCIM
.
- Disconnect the electrical connector.
MKX
- Remove the two screws at the lower LH and RH corners of the of the FCIM .
- Pull back on the FCIM
starting at the bottom and working to the top to release the clips. Remove the FCIM
.
- Disconnect the electrical connector.
All vehicles
- To install, reverse the removal procedure.